Not Same as stock but fits
Hi,
Due to a design flaw, sand and dirt got into my truck clutch/reduction gear and ate up the teeth.
hence this was required. On opening I found the following
1. Replacement part had a thinner shaft.
2. End connector unlike the original did not have a pass thru hole for the screw, but had a D - Shape... Had to use a grub as opposed to the original screw that was holding up the factory reduction gear.
Quality seemed decent, no complains.
From:
rishu dhawan
|
Created on:
10/7/2013 1:50 PM
Was this review helpful?
Yes
No
(
0
/
0)